|
|
|
|
UNILIT 40 (TD 13 FS)
FINISHING MORTAR DESCRIPTION
UNILIT
40 is a dry premixed mineral finishing mortar based on hydraulic, naturally pure
and selected lime. The product performs perfectly where rising damp / capillary
action is prevalent. UNILIT
40 is characterised by a high impact resistance and is resistant against
atmospheric influences. APPLICATION
UNILIT
40 mortar is water repellent but very vapour permeable and is completely
compatible with the UNILIT system as finishing layer. This mortar can also be
applied to damp walls of buildings and cellars. The
optimum vapour permeability allows humidity present in the wall to be able to
rapidly migrate from the structure and UNILIT 40 will withstand the effects of
rising damp / capillary action. TECHNICAL PROPERTIES
Delivery
form
powder Density
1.450 Kg/m³ Tensile
strength
0,5 N/mm² Compression
strength
5 N/mm² after 60 d
6 N/mm² after 90 d Modulus
of elasticity
6.130 N/ mm² Coefficient
of thermal conductivity
l
= 0,67 W/m°K Vapour
diffusion resistance
m = 13,7 pH
value
> 10,5 Fire
classification
non-flammable MO Granular
size
0,7 mm Proportion
water/Unilit 40
0.16 l/kg Mixing
time
3 to 5 minutes CONSUMPTION
Dependent
upon the background : approx. 5 kg/m² Approx.
1,5 to 1,8 kg/m²/mm layer thickness. Layer
thickness approx. : 3 to 4 mm as
finishing layer, applied
in two layers (wet on wet) COLOUR
Beige PREPARATION
The
substrate must be clean and free of all traces of oil and grease.
When the substrate has been treated with an impregnating product
(silicone and similar) it is recommended to consult the supplier or
manufacturer. UNILIT
40 is mixed with clean water. Depending
on the situation and substrate 4 to 5 litres of water are mixed with 25 kg of
powder. The mixing can be done either manually or mechanically.
Mixing time : 3 to 5 minutes. The
mortar can be applied directly to either dry or damp substrates.
If the substrate is too dry, dampen down the surface prior to
overcoating. UNILIT
40 is applied in a total layer thickness of 3 to 4 mm.
UNILIT
40 remains workable for 2 hours, in temperatures between 5°C and 40°C.
The drying period is 24 - 48 hours.
It has to be protected from frost for 48 - 72 hours after its
application. If
desired, a colour finish can be applied afterward with a lime or silicate paint. For silicate paint a waiting period of 2 to 3 weeks must be
respected. PACKING
30
kg bags REMARKS
In
case of doubt regarding the substrate, consult our technical service department.
The material must be stored dry and frost free above ground. The maximum storage
time is 6 months. Our advice and information is given in good faith and
depending on the latest developments of our products. We guarantee the constant
quality of our products, but do not accept any liability concerning the
application. |
|
Arte Constructo bvba - Molenberglei 18 - B- 2627 Schelle (Belgium) tel: +32 (0)3 880.73.73 fax: +32 (0)3 880.73.70
made by stevensschool
|